1.2.10f
* SNR improvement for use case 2x2+0 carrier aggregation.  
* Added clearing all graphs when clearing the all data logs under the maintenance tab.

1.2.10e
* Improvements made to the graphs section under the link Monitoring tab for ACM, RSL and SNR.  

1.2.10d
* Improved control messaging between transceiver module(s) and the baseband board. 
* Updated to allow users to enable/disable Digital Predistortion in the GUI.


1.2.10c

* Fixed an issue with equipment protection showing an invalid display. 
* Upgraded Web Server to latest version. 
* Updates to support latest modem circuit card. Certain components were replaced on the modem card to resolve   obsolescence. Updates to modem card have no effect on performances or functionality. Latest s/w firmware is   backward compatible with earlier modem circuit card.



1.2.9v

* This allows the user to edit SNMPv3 password or create new SNMP users. 
* Fixed an issue with the NTP server sometimes not connecting properly.
* Fixed an issue with trying to log on with different user name account. 
* Added new TR 283.5 for the 8 GHz Band

-------------------------------

1.2.9r

* Added additional security for failed login attempts. 
* Resolved an issue caused by an incorrect default MTU setting. 

1.2.9o

-------------------------------

* Allows for MPLS Unicast/Multicast tagged frames to go transparently in any configuration. This was previously only supported in PB mode for untagged ports"


1.2.9m

-------------------------------

* Fixes a bug which in very rare case prevent the unit from booting up correctly on reboot and requires a power cycle to resolve it.

* Added to the WEB GUI the capability to enable/disable HTTPS and SSH.


* Fixed the use case header to display V as Path A and H for Path B for XPIC configurtion. 

* Simplified the “Ethernet” section in the dashboard page and  added a new “Ethernet” graph page that allows the user to view Tx/Rx rates of all the ports over the past 30 days.

* Added SFP module temperature and laser power level information on the web device Information page for the 1G interface. 

* Resolved an issue relating to payload ethernet port not receiving traffic in rare startups.


Notes:  
Load software on remote side first and then local side.  
Clear web broswers cache after loading this SW verson.